The sales team at BigTray will continue to be here to serve you under the Chefs' Toys brand. For more information, click here. Pick up unavailable for current zip code. Deliver to Shipping restrictions apply. Visit www. I don't want to protect my purchase. List Name. The sales team at BigTray will continue to be here to serve you under the Chefs' Toys brand. For more information, click here.
Non-peel or chip laminated vinyl exterior. Temporarily out of stock. Shipping restrictions apply. Visit www. I don't want to protect my purchase. List Name.
These are provided with hand-brakes. When all castors have been threaded fully, replace grill and lift unit; positioning it into its final location. Units final location should be adequately ventilated. Ensure that the drain hose for hoses are positioned in the pan. Free plug and cord from inside the lower rear of the cooler Do Not Plug In. The unit should be placed close enough to the electrical supply so that extension cords are NEVER used.
TRUE will not warranty any units that are connected to an extension cord. Proper leveling of your TRUE cooler is critical to operating success. Adjust castors or add shims. For GDM freezers 3 inches between the wall and rear of the cabinet will assure proper ventilation.
Position level in the inside floor of the unit near the doors. Level should be parallel to cabinet front. Level cabinet. Position level at the inside rear of cabinet. Again level should be placed parallel to cabinet back. STEP 4 - Raise and block the front side of the cabinet.
The bead must be heavy enough to seal the entire cabinet surface when it is down on the sealant. STEP 8 - Examine to see that cabinet is sealed to floor around entire perimeter. NOTE: Asphalt floors are very susceptible to chemical attack. A layer of tape on the floor prior to applying the sealant will protect the floor. Armstrong Cork - Rubber Caulk.
Products Research Co. Dow Corning Silicone Sealer. Hook shelf clips onto shelf standards. Position all four shelf clips equal in distance from the floor for flat shelves. Lower front of gravity feed TrueTrac organizers to enable proper feed.
Place shelves on shelf clips making sure all corners are seated properly. NOTE: GDM-5 models include an airflow guard on the rear of shelves to maintain an air space at the rear of the cabinet.
Install clip on the side to the rear of organizer see illustration to end of organizer that rests against left or right outside wall. With correct installation, the retainer clip should separate the rear of the organizer from the rear interior wall of the cabinet. Install the top tab of the shelf clip into the proper hole. Push up on the bottom of the clip. See image 1. Bottom tab of the shelf clip will fit tightly. You may need to squeeze or twist the bottom of the shelf clip to install.
After installation, the shelf clip will fit snug into the shelf standard. The shelf clip should not be loose or able to wiggle out of the shelf standard. Install all the shelf clips before installing the shelves. Start at the bottom in terms of shelf installation and work your way up. Always lay the back of each shelf down on the rear clips before the front. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up.
Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. True Refrigeration. TRUE www. TRUE is not responsible for damage incurred during shipment. A Removing skid from bottom of cabinet. STEP 3 - Draw an outline on the base on the floor. Armstrong Cork - Rubber Caulk 6.
0コメント